Xerox VersaLink B7025 Service Manual page 874

6. Position the half rate carriage, Figure
a. Move the half rate carriage (1) to the alignment pin insertion position (the slots in the
lower guide rails).
b. Install the two alignment pins (2).
c. Tighten the two screws (3).
Figure 4 Half rate carriage positioning
7. Tighten one of the rear set screws,
NOTE: The second set screw will not be accessible at this time.
Rear
Set screw
Figure 5 First rear set screw
Repairs and Adjustments
ADJ 60.1
4:
Figure 5.
8. Secure the rear cable to the full rate carriage,
a. Remove the alignment pin from the front of the half rate carriage. Install the align-
ment pin (1) to the rear of the full rate carriage.
b. Tighten the rear cable securing screw (5).
9. Remove both alignment pins.
10. Tighten the other rear set screw,
Rear
Figure 7 Second rear set screw
11. Manually move the full rate carriage to ensure that it moves smoothly.
12. Adjust the front of the carriages.
13. Restore the tool pins to their original positions.
14. Reinstall the lens cover assembly.
April 2017
4-234 Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
Figure 6:
Figure 6 Carriage setting
Figure 7.
Set screw
Launch Issue