C
D
Measure the voltage between the finisher PWB
voltage is approximately +24VDC.
Y
N
Check the +24VDC circuit. Refer to the
a new finisher PWB,
PL 12.14 Item
Enter
dC330
code 012-013. Measure the voltage between the finisher PWB
2 (+) and ground (-). The voltage changes.
Y
N
Install a new finisher PWB,
PL 12.14 Item
Install a new sub paddle solenoid,
PL 12.10 Item
Check the wires and connectors for an intermittent open or short circuit. If the fault persists,
install a new finisher PWB,
PL 12.14 Item
Status Indicator RAPs
012-151A, 012-152
P/J8705
pin 1 (+) and ground (-). The
Wiring
Diagrams. If the circuit is good, install
1.
P/J8705
1.
27.
1.
012-152 Compiler Exit Sensor On Jam Entry RAP
012-152 The compiler exit sensor does not actuate within a specified time after receiving the
sheet exit command (the paper to be ejected has actuated the IOT exit sensor 1).
Procedure
pin
Go to the relevant procedure:
•
Integrated office finisher installed,
•
Office finisher LX installed,
012-151B, 012-152B
April 2017
2-60
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
012-152A
Compiler Exit Sensor On Jam RAP.
Compiler Exit Sensor On Jam RAP.
Launch Issue