Adj 5.3 Dadf Lead Edge Registration - Xerox VersaLink B7025 Service Manual

NOTE: An increment of 1 in NVM = 0.1mm (0.04 inch).
Table 2 Side 2 NVM values
NVM Document Width
711-274 For all sizes
715-057 139.7 to 148 mm
715-059 182 to 194mm
715-061 203.2mm
715-063 210mm
715-065 214.9 to 215.9mm
715-067 254 to 257mm
715-069 266.7 to 267mm
715-071 279.4mm
715-073 297mm
2. If required, NVM values 715-057 to 715-073 can be changed to correct side edge regis-
tration for each individual document size. Refer to Refer to
3. Repeat the Side 2 Check.
Repairs and Adjustments
ADJ 5.2, ADJ 5.3
Document Size
For all sizes
A5 SEF, 5.5x8.5" SEF
B5 SEF, 16K SEF
8x10" SEF, 8x10.5" SEF
A4 SEF, A5 LEF
Letter SEF, Legal SEF, 5.5x8.5" LEF, 8.46x12.4"
SEF, 8.5x13" SEF
B4 SEF, B5 LEF, 8x10" LEF
16K LEF, 8K LEF, 8x10.5" LEF
Letter LEF, 11x15" SEF, 11x17" SEF
A4 LEF, A3 SEF
Table 2.

ADJ 5.3 DADF Lead Edge Registration

Purpose
To correct DADF lead edge registration.
Initial Actions
NOTE: For a description of the print/copy orientation definitions, refer to
entation Definitions.
Before performing this procedure, perform the procedures that follow:
1. dC126 System Registration.
2. ADJ 60.2 IIT Lead Edge Registration.
3. ADJ 5.1 DADF Lead Edge Skew.
Side 1 Check
1. Place the test pattern 82E2010 (A4) or 82E2020 (8.5 x11inch) face up in the DADF input
tray. Ensure that the document guides are correctly adjusted.
2. Make two simplex copies.
3. Use the grids A and B on the copy,
that the lead edge registration error is within +/- 1.6 mm (0.063 inch). The displacement
measured at A and B should be equal.
April 2017
4-228 Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
GP 31 Print/Copy Ori-
Figure 1, measure the lead edge displacement. Check
Launch Issue