Xerox VersaLink B7025 Service Manual page 101

012-151B, 012-152B Compiler Exit Sensor Jam RAP
BSD-ON: BSD 13.7 Office Finisher LX Transportation
Initial Actions
NOTE: Ensure the correct RAP is performed, refer to the
Jam Entry RAP or the 012-152 Compiler Exit Sensor On Jam Entry RAP.
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
• (012-152 Only) Ensure that the chute assembly,
• Switch off, then switch on the machine,
Procedure
Enter dC330 code 012-150. Actuate the compiler exit sensor,
changes.
Y N
Check the wiring between J8869 pin 2 and
a loose or damaged connector. The wiring is good.
Y N
Reconnect or repair as necessary.
Measure the voltage between P/J8988
approximately +5VDC.
Y N
Install a new finisher PWB, PL 13.45 Item
Measure the voltage between P/J8988
the compiler exit sensor. The voltage changes.
Y N
Install a new compiler exit sensor,
Install a new finisher PWB, PL 13.45 Item
Enter dC330 012-038. The transport motor runs.
Y N
Check the wiring between P/J8879
PWB for an open or short circuit, or a loose or damaged connector. The wiring is good.
Y N
Reconnect or repair as necessary.
Measure the resistance of the transport motor between
resistance is approximately 20 Ohms.
Y N
Install a new transport motor, PL 13.08 Item
A B
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
012-151 Compiler Exit Sensor Off
PL 13.35 Item 16 is installed correctly.
GP 10.
PL 13.35 Item 10. The display
P/J8988 pin 5 for an open or short circuit, or
pins 4 and 6 on the finisher PWB. The voltage is
2.
pin 5 on the finisher PWB and ground. Actuate
PL 13.35 Item 10.
2.
on the transport motor and P/J8983 on the finisher
P/J8879 pin 1, 2, 5 and 6.
13.
A B
Install a new finisher PWB,
motor, PL 13.08 Item 13.
Check the components that follow:
• The exit roller, paddle shaft and eject belt for wear, damage or contamination,
• The compiler exit sensor and transport motor circuits for an intermittent condition.
If the fault persists, install a new finisher PWB,
The
April 2017
2-81
PL 13.45 Item 2. If the fault persists, install a new transport
PL 13.45 Item 2.
Status Indicator RAPs
012-151B, 012-152B
PL 13.29.