Xerox VersaLink B7025 Service Manual page 526

116-321, 322, 323, 328, 329, 338 Software Error RAP
116-321 Due to an error in software processing, subsequent processes cannot be performed.
116-322 Due to an error in software processing, subsequent processes cannot be performed.
116-323 During a read/write check at power on, OS/DD detects an error with the ESS-NVRAM
board.
116-328 A failure was detected in the level 2 cache built in the CPU.
116-329 A system call error related to the serial I/F was detected.
116-338 Overall JBA fatal error. Due to an error in software processing, subsequent processes
cannot be performed.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine,
2. Ensure that all connectors on the drive PWB,
Item 6 are securely connected. Ensure all surface mounted modules on both PWBs are
securely connected.
3. Reload the software, GP 4.
4. Perform the OF2 Special Boot Modes RAP.
Status Indicator RAPs
116-321, 322, 323, 328, 329, 338, 116-324
WARNING
GP 10.
PL 1.10 Item 3 and the ESS PWB,
116-324 Exception Fail RAP
116-324 A fatal software exception error has occurred in the controller PWB CPU.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine,
2. Ensure that all connectors on the drive PWB,
Item 6 are securely connected. Ensure all surface mounted modules on both PWBs are
securely connected.
3. Reload the software, GP
4. Check the wiring between the ESS PWB,
5. Initialise the hard disk. Refer to
6. Initialize the Sys - System NVM, refer to dC301.
7. Install a new hard disk,
PL 3.10
April 2017
2-506
WARNING
GP 10. Disconnect the power cord. Electricity can cause
GP 10.
PL 1.10 Item 3 and the ESS PWB,
4.
PL 3.10 Item 6 and the hard disk.
dC355 Hard Disk Diagnostics.
PL 3.10 Item 2.
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
PL 3.10
Launch Issue