Controller Diagnostic Fail Rap - Xerox VersaLink B7025 Service Manual

016-368, 369, 370 Controller Diagnostic Fail RAP

016-368 Cont torino diagnostic fail.
016-369 Cont S2X board diagnostic fail.
016-370 Cont rendering engine diagnosed as having a failure.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine,
2. Ensure that all connectors on the ESS PWB,
Ensure all surface mounted modules are securely connected.
3. Reload the software, GP 4.
4. If the fault persists, install a new ESS PWB,
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
WARNING
GP 10.
PL 3.10 Item 6 are securely connected.
PL 3.10 Item 6.
016-371 Controller USB 1.1 Host Fail RAP
016-371 A defect was detected during a diagnostic check of USB 1.1 host (no communication
with the fax card could be established).
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine,
2. Ensure that all connectors on the fax PWBs,
3. Reload the software, GP 4.
4. Install new components as necessary:.
• Line 1 fax PWB, PL 20.05 Item
• Line 2 fax PWB, PL 20.05 Item
• Line 3 fax PWB, PL 20.05 Item
5. If the fault persists, install a new ESS PWB,
April 2017
2-125
WARNING
GP 10. Disconnect the power cord. Electricity can cause
GP 10.
PL 20.05 are securely connected.
10.
15.
15.
PL 3.10 Item 6.
Status Indicator RAPs
016-368, 369, 370, 016-371