Rep 80.2 Tray 1 Feed/Retard/Nudger Roll - Xerox VersaLink B7025 Service Manual

7. Remove the feed out chute (1), Figure
Figure 4 Feed out chute removal
8. Remove the tray 1 feeder assembly,
a. Remove two screws (1).
b. Remove the tray 1 feeder assembly (2).
Figure 5 Tray 1 feeder assembly removal
Replacement
1. The replacement is the reverse of the removal procedure.
2. If a new tray 1 feeder assembly is installed, enter
counter 954-800.
Repairs and Adjustments
REP 80.1, REP 80.2
4.
Figure 5:
dC132 HFSI Counter. Reset the HFSI

REP 80.2 Tray 1 Feed/Retard/Nudger Roll

Parts List on PL 80.11
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
NOTE: New feed, retard and nudger rolls must be installed at the same time.
1. Pull out tray 1.
2. Remove the tray 1 feed, retard and nudger rolls,
a. Slide the chute (1) forwards.
b. Release the clip, then remove the tray 1 feed, retard and nudger rolls (2).
Replacement
1. The replacement is the reverse of the removal procedure.
2. If new tray 1 feed, retard and nudger rolls are installed, enter
the HFSI counter 954-800.
April 2017
4-178 Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
WARNING
GP 10. Disconnect the power cord
Figure 1:
Figure 1 Roll removal
dC135 HFSI Counter. Reset
Launch Issue