REP 5.1 DADF Removal
Parts List on
PL 5.05
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1.
If a new DADF is to be installed, if possible, record the current software level by either:
•
Printing the configuration report,
•
From the user interface Home screen, touch Device, then About. Scroll down to view
the Software Version.
2.
Remove the upper rear cover,
REP
3.
Disconnect the cable clamps (1), then the connector (2),
Figure 1 Connector
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
WARNING
GP
10. Disconnect the power cord
GP
14.
28.5.
Figure
1.
4.
Remove the DADF,
Figure
Replacement
1.
The replacement is the reverse of the removal procedure.
2.
Install the DADF by inserting the tabs of the counter balance into the grooves of the instal-
lation holes (1),
Figure
3.
April 2017
4-25
2.
Figure 2 DADF removal
Figure 3 DADF replacement
Repairs and Adjustments
REP 5.1