REP 13.9 Eject Cover
Parts List on
PL 13.26
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1.
Remove the eject cover,
Figure
1:
a.
Unlatch the eject cover (1), then move it to the left.
b.
Remove the retaining screw (2).
c.
Push the latch (3) through the hole in the cover.
d.
Remove the cover by moving it to the left.
Figure 1 Eject cover removal
Repairs and Adjustments
REP 13.9
WARNING
GP
10. Disconnect the power cord
Replacement
1.
Align the eject cover (1) with the pins (2) on both sides, then slide it to the right,
NOTE: The left side of the cover will be captured by the pins and cannot be lifted up.
Figure 2 Eject cover alignment
April 2017
4-100
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
Figure
2.
Launch Issue