Other Hdd Fail Rap - Xerox VersaLink B7025 Service Manual

Hide thumbs Also See for VersaLink B7025:
Table of Contents

Advertisement

117-340, 117-342 Other HDD Fail RAP

117-340 A hard disk that was formatted by another machine was detected.
117-342 Storage device incorrect-exchanged fault.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
GP
10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1.
Install a new hard disk,
PL 3.10 Item
2.
If the fault persists:
a.
Switch off, then switch on the machine,
b.
Ensure that all connectors on the drive PWB,
3.10 Item 6
are securely connected. Ensure all surface mounted modules on both
PWBs are securely connected.
c.
Reload the software,
GP
4.
d.
If the fault persists, install a new ESS PWB,
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
WARNING
2.
GP
10.
PL 1.10 Item 3
and the ESS PWB,
PL 3.10 Item
6.
117-343 Log Sending Parameter Fail RAP
117-343 An incorrect setting of the log transfer function was detected:
1.
When the image log function is disabled and the auto transfer function is enabled, transfer
in job units is set.
2.
When the job log auto transfer function is disabled (no hard disk), the auto transfer func-
tion of the log is set to enabled.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1.
Have the customer change the settings of the log transfer function:
For detection condition 1, change the operation method for Log Auto Transfer to
PL
anything other than Transfer in Job Units.
For detection condition 2, check whether a hard disk is installed or change the Auto
Transfer function of the log to disable it.
2.
Reload the software,
GP
4.
3.
Perform the
OF2
Special Boot Modes RAP.
April 2017
2-539
WARNING
GP
10. Disconnect the power cord. Electricity can cause
Status Indicator RAPs
117-340, 117-342, 117-343

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Versalink b7030Versalink b7035

Table of Contents