Xerox VersaLink B7025 Service Manual page 118

012-935B Entrance Sensor RAP
BSD-ON: BSD 13.7 Office Finisher LX Transportation
Initial Actions
NOTE: Ensure the correct RAP is performed, refer to the
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
• Check for obstructions in the paper path
• Check that the finisher is docked correctly to ensure proper transport gate operation.
Procedure
Enter dC330 code 012-100. Actuate the transport entrance sensor,
display changes.
Y N
Check the wiring between J8868 pin 2 and
a loose or damaged connector. The wiring is good.
Y N
Reconnect or repair as necessary.
Measure the voltage between P/J8988
approximately +5VDC.
Y N
Install a new finisher PWB, PL 13.45 Item
Measure the voltage between P/J8988
finisher entrance sensor. The voltage changes.
Y N
Install a new transport entrance sensor,
Install a new finisher PWB, PL 13.45 Item
Install a new finisher PWB, PL 13.45 Item
Status Indicator RAPs
012-935B
012-935 Entrance Sensor Entry RAP.
WARNING
PL 13.35 Item
P/J8988 pin 2 for an open or short circuit, or
pins 3 and 1 on the finisher PWB. The voltage is
2.
pin 2 on the finisher PWB and ground. Actuate the
PL 13.35 Item 10
2.
2.
10. The
April 2017
2-98 Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
Launch Issue