Rep 13.25 Eject Motor; Rep 13.26 Front/Rear Tamper Motor - Xerox VersaLink B7025 Service Manual

REP 13.25 Eject Motor

Parts List on PL 13.27
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Undock the finisher, REP 13.5.
2. Remove the booklet maker, REP 13.31.
3. Remove the rear upper cover, REP
4. Remove the eject motor assembly,
5. Remove four screws, then the eject motor,
Replacement
The replacement is the reverse of the removal procedure.
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
WARNING
GP 10. Disconnect the power cord
13.7.
REP 13.22.
PL 13.27 Item 4.

REP 13.26 Front/Rear Tamper Motor

Parts List on PL 13.28
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the compiler tray,
2. Place the compiler tray upside down on a work surface.
3. Remove the tamper motor,
a. Release the harness (1) from the harness guide.
b. Remove the screw (2), then the harness guide.
c. Disconnect the tamper motor connector (3).
d. Remove both screws, then the relevant tamper motor (4).
Figure 1 Tamper motor removal
Replacement
The replacement is the reverse of the removal procedure.
April 2017
4-121
WARNING
GP 10. Disconnect the power cord
REP 13.17.
Figure 1:
Repairs and Adjustments
REP 13.25, REP 13.26