6.
Remove the FDR 2T cover from the tray 4 feeder assembly,
a.
Remove the screw (1).
b.
Remove the FDR 2T cover (2). Retain the cover for installation onto the new tray 4
feeder assembly.
Figure 3 FDR 2T cover removal
Replacement
Ensure that the FDR 2T cover is installed onto the new tray 4 feeder assembly. Refer to
3.
1.
The replacement is the reverse of the removal procedure.
2.
If new tray 4 feeder assembly is installed, enter
counter 954-803.
Repairs and Adjustments
REP 80.9, REP 80.10
Figure
3.
CAUTION
dC135
HFSI Counter. Reset the HFSI
REP 80.10 3TM PWB
Parts List on
PL 70.23
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Observe ESD procedures during this procedure.
1.
Remove the rear cover,
a.
Remove four screws (1).
b.
Remove the rear cover (2).
Figure
April 2017
4-186
WARNING
GP
10. Disconnect the power cord
Figure 1 ESD Symbol
CAUTION
Figure
1:
Figure 2 Rear cover removal
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
Launch Issue