Top Cover Interlock Open Rap - Xerox VersaLink B7025 Service Manual

A B
Measure the voltage between the finisher PWB
dC330 012-046 and 012-047 alternately. The voltage changes.
Y N
Install a new staple assembly, PL 12.11 Item
Check the wires and connectors for an intermittent open or short circuit. If the fault per-
sists, install a new finisher PWB, PL 12.14 Item
Check the wires and connectors for an intermittent open or short circuit. If the fault persists,
install a new finisher PWB, PL 12.14 Item
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
P/J8731 pin 5 (+) and ground (-). Enter
2.
1.
1.

012-301 Top Cover Interlock Open RAP

BSD-ON: BSD 12.1 Integrated Office Finisher DC Power and Interlock Switching
012-301 The top cover interlock open was detected.
Initial Actions
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP
death or injury. Moving parts can cause injury.
• Check that the top cover can be opened and closed.
• Check the finisher top cover interlock sensor and the finisher top cover interlock +24V
switch, PL 12.10 are correctly installed and undamaged.
• Switch off, then switch on the machine,
Procedure
Enter dC330 code 012-300. Open, then close the top cover to actuate the finisher top cover
interlock sensor. The display changes.
Y N
Check the connections of P/J8701
Y N
Secure the connections.
Check for an open or short circuit between
Y N
Repair the open or short circuit.
Measure the voltage between the finisher PWB
voltage is approximately +5VDC.
Y N
Check the +5VDC circuit. Refer to the
Measure the voltage between the finisher PWB
then close the top cover to actuate the finisher top cover interlock sensor. The
changes.
Y N
Install a new finisher top cover interlock sensor,
Check the wires and connectors for an intermittent open or short circuit. If the fault per-
sists, install a new finisher PWB,
Measure the voltage between the finisher PWB
age is approximately +24VDC.
Y N
Check the +24VDC circuit. Refer to the
finisher PWB, PL 12.14 Item
Check the wires and connectors for an intermittent open or short circuit. If the fault persists,
install a new finisher PWB, PL 12.14 Item
April 2017
2-73
WARNING
10. Disconnect the power cord. Electricity can cause
GP 10.
and P/J8730. The connectors are good.
P/J8701 and P/J8730. The wiring is good.
P/J8701 pin 3 (+) and ground (-). The
Wiring Diagrams.
P/J8701 pin 2 (+) and ground (-). Open,
PL 12.10 Item 20.
PL 12.14 Item 1.
P/J8702 pin 1 (+) and ground (-). The
Wiring Diagrams. If the fault persists, install a new
1.
1.
Status Indicator RAPs
012-291A, 012-301
voltage
volt-