124-327 IOT Speed Change Fail RAP
124-327 A SW error was detected during the procedure for changing IOT speed.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
GP
10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1.
Switch off, then switch on the machine,
2.
Ensure that all connectors on the ESS PWB,
Ensure all surface mounted modules are securely connected.
3.
Reload the software,
GP
4.
4.
If the fault persists, install a new ESS PWB,
Status Indicator RAPs
124-327, 124-328
WARNING
GP
10.
PL 3.10 Item 6
are securely connected.
PL 3.10 Item
6.
124-328 Punch Unit User Initial Set Up RAP
124-328 Punch unit user initial installation screen displayed.
Procedure
Advise the customer to select the punch unit according to the instruction on the UI.
April 2017
2-562
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
Launch Issue