Adj 60.1 Full/Half Rate Carriage Position Adjustment - Xerox VersaLink B7025 Service Manual

ADJ 60.1 Full/Half Rate Carriage Position Adjustment

Parts List on PL 60.15
Purpose
To adjust the position of the full rate carriage and half rate carriage.
Adjustment
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
NOTE: Adjust the position of the carriages at the front and rear separately. Only the procedure
for the rear is described here. The procedure for the front is the same.
1. Open DADF.
2. Remove the document glass, REP
Do not remove the four screws that secure the lens base.
3. Remove the alignment pins from the lens assembly,
a. Remove two screws (1).
b. Remove the alignment pins (2).
Figure 1 Alignment pins
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
WARNING
60.1.
CAUTION
Figure 1:
4. Check that the pulley at the front side is firmly secured. If the pulley is loose, tighten both
set screws, Figure 2.
5. Loosen the two set screws that secure the pulley at the rear,
Rear
April 2017
4-233
Set screws
Figure 2 Front set screws
Figure 3.
Set screws
Figure 3 Rear set screws
Repairs and Adjustments
Front
ADJ 60.1