Xerox VersaLink B7025 Service Manual page 115

012-302B Front Cover Interlock Open RAP
BSD-ON: BSD 13.3 Office Finisher LX Interlock Switching
Initial Actions
NOTE: Ensure the correct RAP is performed, refer to the
Entry RAP.
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
• Check the installation of the front door interlock switch,
• Check that the front cover can be opened and closed.
Procedure
Enter dC330 code 012-302. Open then close the finisher front cover to actuate the front door
interlock switch. The display changes.
Y N
Cheat the front door interlock switch. The display changes.
Y N
Check the wiring between J8982
J8982 pin 2 for an open or short circuit, or a loose or damaged connector. The wir-
ing is good.
Y N
Reconnect or repair as necessary.
Remove the cheater. Measure the voltage between
interlock switch and ground. The voltage is approximately +5VDC.
Y N
Check the wiring from J8891
or a loose or damaged connector. If the wires are good, install a new finisher
PWB, PL 13.45 Item 2.
Cheat the interlock switch. The voltage drops to 0VDC.
Y N
Install a new front door interlock switch,
Install a new finisher PWB, PL 13.45 Item
Check the actuator for damage or misalignment
Check the interlock circuit for an intermittent condition. If the fault persists, install a new finisher
PWB, PL 13.45 Item 2.
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
012-302 Front Cover Interlock Open
WARNING
PL 13.45 Item 19.
pin 3 and J8891 pin 2B, and from J8891
J8891 pin 2A on the front door
pin 2A to J8982 pin 3 for an open or short circuit,
PL 13.45 Item 19.
2.
012-303 Finisher horizontal Transport Cover Open RAP
BSD-ON: BSD 13.5 Office Finisher LX Horizontal Transport
012-303 The finisher horizontal transport cover is open.
Initial Actions
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
• Check the installation of the horizontal transport open sensor,
• Check that the finisher horizontal transport cover can be opened and closed
Procedure
Enter dC330 code 012-303. Actuate the horizontal transport open sensor. The
changes.
Y N
Check the wiring between
loose or damaged connector. The wiring is good.
Y N
pin 2A to Reconnect or repair as necessary.
Measure the voltage between
approximately +5VDC.
Y N
Install a new finisher PWB,
Measure the voltage between
horizontal transport open sensor. The voltage changes.
Y N
Install a new horizontal transport open sensor,
Install a new finisher PWB,
If the fault persists, install a new finisher PWB,
April 2017
2-95
WARNING
GP 10. Disconnect the power cord. Electricity can cause
PL 13.08 Item
J8860 pin 2 and J8897 pin 2 for an open or short circuit, or a
J8897 pins 3 and 1 on the finisher PWB. The voltage is
PL 13.45 Item 2.
J8897 pin 2 on the finisher PWB and ground. Actuate the
PL 13.08 Item 3.
PL 13.45 Item 2.
PL 13.45 Item 2.
Status Indicator RAPs
012-302B , 012-303
3.
display