Iq19 White Spots Rap - Xerox VersaLink B7025 Service Manual

• Secondary image quality defects may occur, such as stretched cross process mag-
nification, paper jams or banding 35mm (1.4 inches) from the trail edge.
• If stretched cross process magnification occurs, also adjust the value of NVM 2 in
Table 1.
Table 1 NVM values
NVM 1
Paper Type Paper Weight Chain-
Link
Light Card 106 to 169gsm 746-091 0 - 120 759-045 to
Extra-HW 170gsm and 746-092 0 - 120 759-048 to
above
Labels 106 to 169gsm 746-093 0 - 120 759-051 to
HW Labels 170gsm and 746-094 0 - 120 759-054 to
above
Envelopes - 746-097 0 - 120 -
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
NVM 2
Range Chain-Link New Value
For every 30 step
759-047 increase in the value of
759-071 to NVM 1, also increase
759-073 the value of NVM 2 by
one step.
759-050
759-053
759-056

IQ19 White Spots RAP

Blank areas spread irregularly over the whole page. Refer to
Ensure IQ1 Image Quality Entry RAP is performed before starting this RAP.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
Remove, then reinstall the drum cartridge,
machine, GP 10. Make a print. The image quality defect persists.
Y N
Perform SCP 5 Final Actions.
A
April 2017
3-17
Figure 1.
Figure 1 Example
WARNING
GP 10. Disconnect the power cord. Electricity can cause
PL 90.20 Item 1. Switch off, then switch on the
Imaqe Quality
IQ18, IQ19