Nvm Fail Entry Rap - Xerox VersaLink B7025 Service Manual

A
Y N
Install a new eject home sensor,
Check the wires and connectors for an intermittent open or short circuit. If the fault per-
sists, install a new finisher PWB, PL 12.14 Item
Enter dC330 code 012-054 and 012-056 alternately. The eject motor runs.
Y N
Check the connections of P/J8706 and P/J8741. The connectors are good.
Y N
Secure the connections.
Check for an open or short circuit between
Y N
Repair the open or short circuit.
Measure the voltage between the finisher PWB
between P/J8706 pin 15 (+) and ground (-). The voltage is approximately +24VDC.
Y N
Check the +24VDC circuit. Refer to the
Check the eject motor drive mechanism for deformed parts, broken parts, and/or belt
damage The drive mechanism is good.
Y N
Repair defects or damage to the drive mechanism. Install new components as nec-
essary, PL 12.25.
Install a new eject motor, PL 12.25 Item
PWB, PL 12.14 Item 1.
Check the wires and connectors for an intermittent open or short circuit. If the fault persists,
install a new finisher PWB, PL 12.14 Item
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
PL 12.26 Item 9.
1.
P/J8706 and P/J8741. The wiring is good.
P/J8706 pin 13 (+) and ground (-), and
Wiring Diagrams.
15. If the fault persists, install a new finisher
1.

012-210 NVM Fail Entry RAP

012-210 An error is detected at NVM access.
Procedure
Go to the relevant procedure:
• Integrated office finisher installed,
• Office finisher LX installed, 012-210B
April 2017
2-63
012-210A NVM Fail RAP.
Stacker Tray Fail RAP.
Status Indicator RAPs
012-161A, 012-210