License Required (Printer Kit) Rap - Xerox VersaLink B7025 Service Manual

016-219 License Required (Printer Kit) RAP

016-219 The ROM was replaced without license (printer kit software key not set).
Procedure
Perform the steps that follow:
1. Switch off, then switch on the machine,
2. Set the printer kit SW key to 'Enabled'.
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
GP 10.
016-220 to 016-226, 240 S2X Error RAP
016-220 A unrecoverable error was detected at the S2X PWB.
016-221 Communication with the S2X PWB has failed.
016-222 An error has occurred in the S2X PWB self-diagnostics.
016-223 The S2X PWB has failed the write/read test of the internal SDRAM.
016-224 The S2X PWB has failed to access to the internal PCI space.
016-225 The S2X PWB failed the ROM check sum test.
016-226 The S2X PWB failed to detect the video clocks sent from the IIT.
016-227 The S2X PWB failed the write/read test of the internal DDR memory.
016-228 The S2X PWB failed the desired value comparison of the high-compression process
results using the internal test patterns.
016-240 The high compression PDF board (S2X) failed the NVM checksum
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine,
2. Reload the software, GP 4.
3. If the fault persists, install a new ESS PWB,
April 2017
2-109
WARNING
GP 10. Disconnect the power cord. Electricity can cause
GP 10.
PL 3.10 Item 6.
Status Indicator RAPs
016-219, 016-220 to 016-226, 240