Controller And Ui Configuration Rap - Xerox VersaLink B7025 Service Manual

116-319 Controller and UI Configuration RAP

BSD-ON: BSD 2.1 Control Panel
116-319 A mismatch between the installed ROM and UI.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine,
2. Ensure that all connectors on the UI assembly,
3.10 Item 6 are securely connected. Ensure all surface mounted modules on both PWBs
are securely connected.
3. Reload the software, GP 4.
4. If the fault persists, install new components as necessary:
• UI assembly, PL 2.05 Item 7.
• ESS PWB, PL 3.10 Item 6.
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
WARNING
GP 10.
PL 2.05 Item 7 and the ESS PWB,
116-320, 116-345 Process Error RAP
116-320 Fatal error of the STREAMZ. A problem has occurred in the software processing and
it is unable to continue with the subsequent processes.
116-345 Token Ring Control IC Access error.
Procedure
Switch off, then switch on the machine,
PL
April 2017
2-505
GP 10.
Status Indicator RAPs
116-319, 116-320, 116-345