Rep 80.27 Hcf Feed/Lift Motor; Rep 80.28 Ttm Drive Belt - Xerox VersaLink B7025 Service Manual

REP 80.27 HCF Feed/Lift Motor

Parts List on PL 80.60
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Undock the HCF, REP 70.4.
2. Remove rear cover, PL 70.45 Item
3. Disconnect the connector from the motor.
NOTE: Be careful when removing the motor as it is meshed to a hidden gear.
4. While supporting the motor with one hand, remove two screws then the HCF feed/lift
motor (1), Figure 1.
Figure 1 HCF feed/lift motor removal
Replacement
The replacement is the reverse of the removal procedure.
Repairs and Adjustments
REP 80.27, REP 80.28
WARNING
GP 10. Disconnect the power cord
10.

REP 80.28 TTM Drive Belt

Parts List on PL 70.85
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the TTM rear cover,
2. Remove the takeaway motor 2,
3. Remove the TTM drive belt,
Replacement
1. The replacement is the reverse of the removal procedure.
2. Ensure that the drive belt (1) is installed as shown in
April 2017
4-204 Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
WARNING
GP 10. Disconnect the power cord
PL 70.95 Item 8.
REP 80.37.
PL 70.85 Item 10.
Figure 1.
Figure 1 Belt installation
Launch Issue