Service Fail Rap - Xerox VersaLink B7025 Service Manual

117-347, 349, 350 Service Fail RAP

117-347 When the SEEP extension billing counter have been used and billing count cannot be
performed as new extension counter cannot be obtained.
117-349 Detects this fail when enters a state where it is unable to continue operating as GRS.
117-350 A problem has occurred in the AirPrint scan service software processing and it is
unable to continue with the subsequent processes.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine,
2. Ensure that all connectors on the drive PWB,
Item 6 are securely connected. Ensure all surface mounted modules on both PWBs are
securely connected.
3. Reload the software, GP 4.
4. Perform the OF2 Special Boot Modes RAP.
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
WARNING
GP 10.
PL 1.10 Item 3 and the ESS PWB,
117-348 Uninitialized Used SD Card RAP
117-348 An un-initialized SD card that had been used in another machine was recognized.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine,
2. Initialize the NVM, perform
3. Ensure that all connectors on the drive PWB,
Item 6 are securely connected. Ensure all surface mounted modules on both PWBs are
securely connected.
4. Reload the software, GP
5. If the fault persists, install a new ESS PWB,
PL 3.10
April 2017
2-541
WARNING
GP 10. Disconnect the power cord. Electricity can cause
GP 10.
dC301 NVM Initialization.
PL 1.10 Item 3 and the ESS PWB,
4.
PL 3.10 Item 6.
117-347, 349, 350, 117-348
PL 3.10
Status Indicator RAPs