Replacement
1.
The replacement is the reverse of the removal procedure.
Take care when removing and reinstalling the SEEPROM. The pins are easily damaged.
2.
Remove the SEEPROM (1) from the old DADF PWB, then install it onto the new DADF
PWB,
Figure
4.
Figure 4 SEEPROM
If the original SEEPROM cannot be reused, the feed count, jam count and HFSI count will be
lost.
3.
If the SEEPROM is damaged during removal and cannot be reused, enter
read/Write. Enter the DADF NVM settings listed below according to the NVM Setting List
that was supplied with the machine:
•
711-140
•
711-141
•
711-142
•
711-143
•
711-144
•
711-270
•
711-271
•
711-272
•
711-273
•
711-274
•
711-275
NOTE: The list is located in tray 1, beneath the RAI cover,
4.
Check the machines current software level against the software level recorded prior to
installation of the new DADF PWB. If necessary, reload the software,
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
CAUTION
CAUTION
dC131
PL 70.05 Item
10.
GP
4.
REP 5.6 Upper Feeder Assembly
Parts List on
PL 5.10
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1.
Remove the DADF front cover,
2.
Remove the DADF rear cover,
3.
Remove the front hinge bracket,
a.
Remove the screw (1).
b.
Remove the front hinge bracket (2).
NVM
Figure 1 Front hinge bracket removal
April 2017
4-31
WARNING
GP
10. Disconnect the power cord
REP
5.3.
REP
5.4.
Figure
1:
Repairs and Adjustments
REP 5.5, REP 5.6