Rear Tamper Home Sensor Fail Entry Rap - Xerox VersaLink B7025 Service Manual

012-224, 012-263 Rear Tamper Home Sensor Fail Entry
RAP
012-224 The rear tamper home sensor failed to actuate within the specified time.
012-263 The rear tamper home sensor failed to deactuate within the specified time.
Procedure
Go to the relevant procedure:
• Integrated office finisher installed,
RAP.
• Office finisher LX installed, 012-224B, 012-263B
Status Indicator RAPs
012-224, 012-263, 012-224A, 012-263A
012-224A, 012-263A Rear Tamper Home Sensor Fail
Rear Tamper Home Sensor Fail RAP.
012-224A, 012-263A Rear Tamper Home Sensor Fail RAP
BSD-ON: BSD 12.4 Integrated Office Finisher Tamping and Offset
Initial Actions
NOTE: Ensure the correct RAP is performed, refer to the
Home Sensor Fail Entry RAP.
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
• Check the rear tamper home sensor,
eign object and that the actuator is not broken.
• Switch off, then switch on the machine,
Procedure
Check the rear tamper for any foreign object, deformation and binding that prevents it from
moving. The rear tamper is good.
Y N
Repair the deformation and remove the foreign object(s) and the binding. Install new com-
ponents as necessary, PL 12.26.
Check the drive mechanism to the rear tamper for a deformed or broken part and not-seated
gears. The drive mechanism is good.
Y N
Repair the rear tamper drive mechanism. Install new components as necessary,
12.26.
Enter dC330 code 012-221. Manually move the rear tamper to actuate the front tamper home
sensor. The display of changes.
Y N
Check the connections of P/J8700
Y N
Secure the connections.
Check for an open or short circuit between
Y N
Repair the open wire or short circuit.
Measure the voltage between the finisher PWB
voltage is approximately +5VDC.
Y N
Check the +5VDC circuit. Refer to the
Measure the voltage between the finisher PWB
ally move the rear tamper to actuate the front tamper home sensor. The
changes.
A
April 2017
2-68 Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
012-224, 012-263
WARNING
GP 10. Disconnect the power cord. Electricity can cause
PL 12.25 Item 9 is correctly installed and has no for-
GP 10.
and P/J8726. The connectors are good.
P/J8700 and P/J8726. The wiring is good.
P/J8700 pin 12 (+) and ground (-). The
Wiring Diagrams.
P/J8700 pin 11 (+) and ground (-). Manu-
Rear Tamper
PL
voltage
Launch Issue