Rep 1.1 Hvps - Xerox VersaLink B7025 Service Manual

REP 1.1 HVPS

Parts List on PL 1.10
Removal
NOTE: A video of this procedure is available on the EDOC. The video is accessible from the
Library menu on the Service Interface.
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Figure 1 ESD Symbol
Observe ESD procedures during this procedure.
1. Remove the upper rear cover, REP
2. Remove the lower rear cover, REP
3. Remove the ESS PWB chassis assembly,
4. Remove the LVPS assembly, REP
5. Disconnect three connectors (1), then release the harness from the clamp (2),
Figure 2 Connectors
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
WARNING
GP 10. Disconnect the power cord
CAUTION
28.5.
28.6.
REP 3.2.
1.4.
6. Prepare to remove the HVPS,
a. Remove four screws (1).
When moving the drive PWB assembly, take care not to damage the harnesses.
b. Move the drive PWB assembly (2) in the direction of the arrow.
Figure 2.
April 2017
4-5
Figure 3:
CAUTION
Figure 3 Preparation
Repairs and Adjustments
REP 1.1