Rep 13.4 H-Transport Motor; Rep 13.5 Finisher Lx Undocking - Xerox VersaLink B7025 Service Manual

REP 13.4 H-Transport Motor

Parts List on PL 13.08
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the H-transport assembly,
2. Remove the H-transport rear cover,
3. Place the H-transport top down on a work surface.
4. Remove the H-transport motor, Figure
a. Remove the screw, then the shield (1).
b. Disconnect the connector (2).
c. Loosen two screws to release the belt tension (3).
d. Remove two screws (3), then remove the H-transport motor.
Figure 1 H-transport motor removal
Replacement
The replacement is the reverse of the removal procedure.
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
WARNING
GP 10. Disconnect the power cord
REP 13.1.
PL 13.06 Item 9.
1:

REP 13.5 Finisher LX Undocking

Parts List on PL 13.05
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Disconnect the finisher power cord, the H-transport connector and the finisher connector
from the IOT.
Take care not to topple the finisher. The finisher is unstable when un-docked from the machine.
2. Raise the feet (1) to free the finisher,
3. Open the finisher front door.
April 2017
4-97
WARNING
GP 10. Disconnect the power cord
CAUTION
Figure 1.
Figure 1 Finisher feet
Repairs and Adjustments
REP 13.4, REP 13.5