Puncher Waste Bin Not Set Rap - Xerox VersaLink B7025 Service Manual

024-926, 963, 990 Puncher Waste Bin Not Set RAP

BSD-ON: BSD 13.6 Office Finisher LX Punch
024-926 The puncher waste bin is not installed correctly or there is a failure in the punch box
set sensor or related circuitry.
024-963 The amount of waste has become equal to or over the number that makes the punch
dust box full.
024-990 Punch dust full.
Initial Actions
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
• Empty the punch box, PL 13.06 Item
• Check for any debris or obstructions in the path of the punch waste bin or the punch box
set sensor.
Procedure
Enter dC330, code 012-275, punch box set sensor. Remove, then reinstall the punch waste
bin. The display changes.
Y N
Check the punch box set sensor, refer to
ponents as necessary:
• Punch box set sensor, PL 13.09 Item
• (Integrated office finisher) finisher PWB,
• (Office finisher LX) finisher PWB,
Reload the software, GP 4. If the fault persists, install a new finisher PWB (integrated office fin-
isher), PL 12.14 Item 1 or (office finisher LX),
Status Indicator RAPs
024-926, 963, 990, 024-928
WARNING
11.
GP 7 How to Check a Sensor. Install new com-
5.
PL 12.14 Item 1.
PL 13.45 Item 2.
PL 13.45 Item 2.
024-928 Scratch Sheet Compile Entry RAP
024-928 Abnormal paper (scratch sheet), which is notified from the IOT via the sheet integrity
command, was output to the finisher.
Procedure
Perform the relevant procedure:
• Integrated office finisher installed,
• Office finisher LX installed,
April 2017
2-320 Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
024-928A Scratch Sheet Compile RAP.
024-928B Scratch Sheet Compile RAP.
Launch Issue