Rep 80.24 Hcf Retard Lever Spring - Xerox VersaLink B7025 Service Manual

REP 80.24 HCF Retard Lever Spring

Parts List on PL 80.62
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the HCF feeder, REP 80.21.
2. Place the feeder on a flat surface. Release the green lever to open the upper feeder
assembly.
3. Remove the retard lever spring, Figure
a. Remove the lower chute (1).
b. Remove the plastic cover (2).
c. Remove the retard roll (3).
d. Remove the E-rings on the lever and spring.
e. Remove the lever (4).
NOTE: Note how the spring extension fits into the lever.
f. Remove the retard lever spring (5).
Repairs and Adjustments
REP 80.24
WARNING
GP 10. Disconnect the power cord
1:
Replacement
1. The replacement is the reverse of the removal procedure.
2. Ensure that the plastic pads on the lower chute fit in the track before pushing it in.
April 2017
4-202 Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
Figure 1 Retard lever spring
Launch Issue