Front Tamper Home Sensor Fail Entry Rap - Xerox VersaLink B7025 Service Manual

B
Y N
Secure the connections.
Check for an open or short circuit between
Y N
Repair the open or short circuit.
Enter dC330 code 012-060. Measure the voltage between the finisher PWB
1 (+) and ground (-). The voltage changes.
Y N
Check the +24VDC circuit. Refer to the
a new finisher PWB, PL 12.14 Item
Enter dC330 code 012-061. Measure the voltage between the finisher PWB
2 (+) and ground (-). The voltage changes.
Y N
Check the +24VDC circuit. Refer to the
a new finisher PWB, PL 12.14 Item
Check the wires and connectors for an intermittent open and short circuit. If the fault per-
sists, install a new stacker motor, PL 12.20 Item
Check the wires and connectors for an intermittent open or short circuit. If the fault persists,
install a new finisher PWB, PL 12.14 Item
Status Indicator RAPs
012-211A, 012-221, 012-223
P/J8711 and P/J8736. The wiring is good.
P/J8711
Wiring Diagrams. If the fault persists, install
1.
P/J8711
Wiring Diagrams. If the fault persists, install
1.
9.
1.
012-221, 012-223 Front Tamper Home Sensor Fail Entry
RAP
012-221 The front tamper home sensor failed to actuate within the specified time.
012-223 The front tamper home sensor failed to deactuate within the specified time.
pin Procedure
Go to the relevant procedure:
• Integrated office finisher installed,
RAP
• Office finisher LX installed, 012-221B, 012-223B
pin
April 2017
2-66 Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
012-221A, 012-223A Front Tamper Home Sensor Fail.
Front Tamper Home Sensor Fail RAP.
Launch Issue