Rep 12.15 Stacker Tray Assembly - Xerox VersaLink B7025 Service Manual

REP 12.15 Stacker Tray Assembly

Parts List on PL 12.06
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the integrated office finisher,
2. Remove the front inner cover, PL 12.05 Item
3. Remove the rear cover, PL 12.05 Item
4. Turn over the integrated office finisher.
5. Remove the bottom cover, PL 12.06 Item
6. Remove the tray cover, PL 12.06 Item
7. Disconnect the connector, Figure 1:
a. Release the clamp (1).
b. Remove the clamp (2).
c. Release the harness (3) from the retainer.
d. Release the clamp (4).
e. Disconnect the connector (5).
f. Release the harness (6) from the retainer.
Figure 1 Connector
Repairs and Adjustments
REP 12.15
WARNING
GP 10. Disconnect the power cord
REP 12.1.
6.
14.
1.
3.
8. Release the wiring, Figure
a. Release five clamps (1).
b. Release the harness (2) from the retainers.
9. Remove the stacker sensor assembly,
a. Remove the screw (1).
b. Remove the stacker sensor assembly (2).
c. Release the four clamps (3).
d. Disconnect two connectors (4).
Figure 3 Stacker sensor assembly removal
April 2017
4-74 Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
2:
Figure 2 Harness release
Figure 3:
Launch Issue