Procedure Notes - Rotax 914 Series Maintenance Manual

2.3)

Procedure notes

When carrying out maintenance and service work, respect without fail the safety
regulations.
▲ WARNING: Principally ensure the following at each maintenance event
■ CAUTION:
At maintenance of cooling-, lubricating and fuel system take care without fail that
no contamination, metal chips, foreign material and/or dirt enters the system.
▲ WARNING: Always allow engine to cool down to outside air temperature
Before re-using parts disassembled, clean, check and refit them per instruc-
tions.
■ CAUTION:
Before every re-assembly check assembled components whether parts are
missing. Only use adhesives, lubricants, cleaning agents and solvents indicated
in the maintenance instructions. If not respected, damage may be the conse-
quence.
▲ WARNING: Exactly observe the tightening torques for screws and nuts.
Effectivity 914 Series
Edition 1 / Rev. 0
BRP-Rotax
MAINTENANCE MANUAL
- Ignition „OFF" and system grounded,
- Disconnect battery
- Secure engine against unintentional operation.
At maintenance work which requires ignition „ON" and battery
connected, take care of the following:
- Secure the propeller against unintentional turning by hand
and
- Secure and observe propeller zone.
This precautionary measure serves to avoid any injuries in case
of an unintentional start of the engine. Non-compliance can
result in injuries or death.
The ignition is switched on, as long as the ground-cable
(P lead) is not properly connected to ground.
before start of any work.
Severe burns and scalds may result if this is not respected.
Generally, all metal parts are cleaned with a suitable cleaning
agent.
Overtightening or too loose connection could cause serious
engine damage.
05-00-00
page 7
May 01/2007