Enabling Information Output To A Log Host - Huawei Quidway S3100 Series Operation Manual

Operation Manual – Information Center
Quidway S3100 Series Ethernet Switches
Note:
Running the info-center synchronous command during debug information collection
may result in a command prompt echoed after each item of debug information. To
avoid unnecessary output, it is recommended that you disable synchronous terminal
output in such cases.

1.2.2 Enabling Information Output to a Log Host

Table 1-5 lists the related configurations on the switch.
Table 1-5 Enable information output to a log host
Operation
Enter system view
Enable
information center
Enable information
output to a log host
Configure
source
through which log
information is sent
to the log host
Define
information source
Set the format of
the time stamp to
be sent to the log
host
Command
system-view
the
info-center enable
info-center
host-ip-addr
{ channel-number
channel-name
local-number
{ chinese | english } ]
the
interface
info-center loghost source
interface-type interface-number
info-center
{ modu-name
an channel { channel-number |
channel-name } [ { log | trap |
debug } * { level severity | state
state } * ]
info-center
loghost { date | no-year-date |
none }
Huawei Technologies Proprietary
loghost
[ channel
|
} | facility
| language
source
| default }
timestamp
1-6
Chapter 1 Information Center
Description
—
Optional
By default, the information
center is enabled.
Required
By default, the switch does
not output information to
the log host.
Be sure to set the correct
IP address. A loopback IP
address will cause an error
message prompting invalid
address.
Optional
Required
Optional