Sending The Information To Log Buffer - Huawei Quidway S6500 Series Operation Manual

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches
Table 4-32 Configuring the output format of time-stamp
Configure the output format of the
time-stamp
Output time-stamp is disabled
4) Enabling terminal display function
To view the output information at the Telnet terminal or dumb terminal, you must first
enable the corresponding log, debugging and trap information functions at the switch.
For example, if you have set the log information as the information sent to the Telnet
terminal or dumb terminal, now you need to use the terminal logging command to
enable the terminal display function of log information on the switch, then you can view
the information at the Telnet terminal or dumb terminal.
Perform the following operation in user view:
Table 4-33 Enabling terminal display function
Enable terminal display function of log, debugging and
trap information
Disable terminal display function of the above
information
Enable terminal display function of debugging
information
Disable terminal display function of debugging
information
Enable terminal display function of log information
Disable terminal display function of log information
Enable terminal display function of trap information
Disable terminal display function of trap information

4.5.6 Sending the Information to Log Buffer

To send configuration information to log buffer, follow the steps below:
1) Enabling info-center
Perform the following operation in system view.
Operation
Operation
Huawei Technologies Proprietary
Chapter 4 System Maintenance and Debugging
Command
info-center timestamp
debugging } { boot | date | none }
undo info-center timestamp { log | trap |
debugging }
4-21
{ log | trap
Command
terminal monitor
undo terminal monitor
terminal debugging
undo terminal debugging
terminal logging
undo terminal logging
terminal trapping
undo terminal trapping
|