Configuring Local Port Mirroring - Huawei Quidway S1700 Series Web User Manual

Quidway S1700 Series Ethernet Switches
Web User Manual
Configuring by Port Range
Use the Interface > Port > General (Configure by Port Range) page to enable/disable
interfaces, set auto-negotiation and the interface capabilities to advertise, or manually fix the
speed, duplex mode, and flow control.
Figure 4-3 Configuring Connections by Port Range
1. Click Interface > Port > General. Select Configure by Port Range from the Action List.
Figure 4-3
2. Specify the Port Range and setup the configuration parameters.
3. Click Apply. It takes effect immediately.
View the port status by clicking Interface > Port > General and selecting Show Information
from the Action List.
----End

4.1.2 Configuring Local Port Mirroring

Use the Interface > Port > Mirror page to mirror traffic from any source port to a target port
for real-time analysis. You can then attach a logic analyzer or RMON probe to the target port
and study the traffic crossing the source port in a completely unobtrusive manner.
To add a local mirror session:
1. Click Interface > Port > Mirror. Select Add from the Action List.
Issue 01 (2011-11-17)
is displayed.
Traffic can be mirrored from one or more source ports to a destination port on the same
switch (local port mirroring as described in this section).
Target port speed should match or exceed source port speed, otherwise traffic may be
dropped from the target port.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
4 Interface Configuration
Figure 4-4 is displayed.
27