Set Up Configuration Environment Through Telnet; Connect Pc To Ethernet Switch Through Telnet - Huawei Quidway S5000 Series Operation Manual - Getting Started

Operation Manual - Getting Started
Quidway S5000 Series Ethernet Switches
Step 4: Input a command to configure the Ethernet switch or view the operation state.
Input a "?" for an immediate help. For details of specific commands, refer to the
following chapters.

2.2 Set up Configuration Environment through Telnet

2.2.1 Connect PC to Ethernet Switch through Telnet

After you have correctly configured IP address of a management VLAN interface for an
Ethernet Switch via Console port (using ip address command in VLAN interface view),
and added the port (that connects to a terminal) to this VLAN (using port command in
VLAN view), you can telnet this Ethernet switch and configure it
Step 1: Authenticate the Telnet user via the Console port before the user logs in by
Telnet.
Note:
By default, the password is required for authenticating the Telnet user to log in the Ethernet switch. If a
user logs in via the Telnet without password, he will see the prompt "password required, but none set.".
<Quidway> system-view
Enter system view , return user view with Ctrl+Z.
[Quidway] user-interface vty 0
[Quidway-ui-vty0] set authentication password simple xxxx (xxxx is the preset login
password of Telnet user)
Step 2: To set up the configuration environment, connect the Ethernet port of the PC to
that of the Ethernet switch via the LAN.
Chapter 2 Logging in Ethernet Switch
2-3