Displaying And Maintaining Rip Configuration; Rip Configuration Example - Huawei Quidway S3900 Series Operation Manual

Operation Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510

3.6 Displaying and Maintaining RIP Configuration

After the above configuration, you can use the display command in any view to
display the running status of RIP and verify the RIP configuration. You can use the
reset command in RIP view to reset the system configuration related to RIP.
Table 3-17 Display and debug RIP configuration
Display the current RIP running
status
information
Reset the system configuration
related to RIP

3.7 RIP Configuration Example

I. Network requirements
As shown in Figure 3-1, Switch C is connected to subnet 117.102.0.0 through an
Ethernet port. Switch A and Switch B are connected to networks 155.10.1.0 and
196.38.165.0 respectively through Ethernet ports. Switch C, Switch A and Switch B
are interconnected through Ethernet 110.11.2.0. It is required to configure RIP
correctly to ensure the interworking between the networks connected to Switch C,
Switch A and Switch B.
II. Network diagram
Interface address:
110.11.2.3/24
Switch C
Network address:
117.102.0.0/16
Figure 3-1 RIP configuration
Operation
and configuration
Interface address:
155.10.1.1/24
Interface address:
Ethernet
110.11.2.1/24
Interface address:
117.102.0.1/16
Huawei Technologies Proprietary
Command
display rip
reset
Network address:
155.10.1.0/24
Switch A
Switch B
Interface address:
Network address:
196.38.165.1/24
196.38.165.0/24
3-13
Chapter 3 RIP Configuration
Description
You can execute the
display command in
any view.
Use this command in
RIP view.
Network address:
110.11.2.2/24