Leaf Node Configuration - Huawei Quidway S3900 Series Operation Manual

Operation Manual – MSTP
Quidway S3900 Series Ethernet Switches-Release 1510
Operation
Disable MSTP on the
port
Other MSTP-related settings can take effect only after MSTP is enabled on the switch.
II. Configuration example
# Enable MSTP on the switch and disable MSTP on Ethernet1/0/1 port.
Configure in system view.
<Quidway> system-view
[Quidway] stp enable
[Quidway] stp interface ethernet1/0/1 disable
Configure in Ethernet port view.
<Quidway> system-view
[Quidway] stp enable
[Quidway] interface ethernet1/0/1
[Quidway-Ethernet1/0/1] stp disable

1.3 Leaf Node Configuration

Table 1-21 lists MSTP-related configurations about leaf nodes.
Table 1-21 Leaf node configuration
Operation
MSTP configuration
MST
configuration
Command
stp disable
Remarks
Required
To prevent
topology jitter caused by
other
configurations,
recommended to enable
MSTP after
other configurations.
region
Required
Huawei Technologies Proprietary
1-25
Chapter 1 MSTP Configuration
Optional
By default,
enabled on all ports after
you enable MSTP in system
view.
To enable a switch to
operate more flexibly, you
can disable
specific
MSTP-disabled ports do not
participate in spanning tree
generation, this operation
saves CPU resources.
Related section
network
Section
related
Configuration"
you are
performing
Section 1.2.2 "MST Region
Configuration"
Description
MSTP is
MSTP on
ports. As
1.2.14 "MSTP