Mstp Configuration; Leaf Node Configuration - Huawei Quidway S3100 Series Operation Manual

Operation Manual – MSTP
Quidway S3100 Series Ethernet Switches
Operation
Disable MSTP on
the port
Other MSTP-related settings can take effect only after MSTP is enabled on the switch.
II. Configuration example
# Enable MSTP on the switch and disable MSTP on Ethernet1/0/1 port.
Configure in system view.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] stp enable
[Quidway] stp interface ethernet1/0/1 disable
Configure in Ethernet port view.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] stp enable
[Quidway] interface ethernet1/0/1
[Quidway-Ethernet1/0/1] stp disable

1.3 Leaf Node Configuration

Table 1-20 lists MSTP-related configurations about leaf nodes.
Table 1-20 Leaf node configuration
Operation
MSTP
configuration
MST
configuration
Command
stp disable
Description
Required
To prevent network topology
jitter caused by other related
configurations,
recommended
MSTP after performing other
configurations.
region
Required
Huawei Technologies Proprietary
Optional
By default, MSTP is enabled
on all ports after you enable
MSTP in system view.
To enable a switch to operate
more flexibly, you can disable
MSTP on specific ports. As
MSTP-disabled ports do not
participate in spanning tree
generation,
saves CPU resources.
Section
you are
Configuration"
to enable
Section 1.2.2
Configuration"
1-24
Chapter 1 MSTP Configuration
Description
this operation
Related section
1.2.13 "MSTP
"MST Region