Configuring The Network Management Function In Rip; Establishing The Configuration Task; Binding Rip To Mibs - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
l
l
l
l
----End

2.9 Configuring the Network Management Function in RIP

By binding RIP to MIBs, you can view and configure RIP through the NMS.

2.9.1 Establishing the Configuration Task

Before binding RIP to MIBs, familiarize yourself with the applicable environment, complete
the pre-configuration tasks, and obtain the data required for the configuration. This will help
you complete the configuration task quickly and accurately.
Applicable Environment
After performing configuration procedures in this section, you can bind RIP to a MIB.
Pre-configuration Tasks
Before configuring the network management function in RIP, complete the following tasks:
l
l
Data Preparation
None.

2.9.2 Binding RIP to MIBs

Before binding RIP to MIBs, you need to specify the RIP process ID.
Context
Do as follows on the RIP switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Issue 01 (2012-03-15)
Run the display rip process-id database [ verbose ] command to check all activated RIP
routes in the database.
Run the display rip process-id interface [ interface-type interface-number ] [ verbose ]
command to check information about the RIP interface.
Run the display rip process-id neighbor [ verbose ] command to check information about
RIP neighbors.
Run the display rip process-id route command to check all the RIP routes that are learned
from other switchs.
Configuring IP addresses for interfaces to ensure that neighboring nodes are reachable at
the network layer
Configuring Basic RIP Functions
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 RIP Configuration
48