Renault Laguna III Manual page 2780

ON-BOARD TELEMATICS SYSTEM
Central control: Removal - Refitting
NAVIGATION AID 1 LEVEL or NAVIGATION AID 4
Equipment required
Diagnostic tool
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Switch off the ignition.
WARNING
T o prevent damaging the navigation system, wait
1 minute after switching off the + after ignition
feed.
a Remove the centre console upper panel (see Cen-
tre console upper front panel: Removal - Refit-
ting) (57A, Interior equipment).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Unclip the central control at (1) .
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Clip the central control onto the centre console up-
per face.
II - FINAL OPERATION
a Refit the centre console upper panel (see Centre
console upper front panel: Removal - Refitting)
(57A, Interior equipment).
a In the event of a replacement, apply the after repair
procedure using the Diagnostic tool :
- connect the Diagnostic tool,
- select "Navigation computer",
- go to repair mode,
- display the "Before/after repair procedure" for the
computer selected,
- select "Central control" in the "List of components
stored in the computer" section,
- carry out the operations described in the "After re-
pair procedure" section.
111446
83C-8
83C