Table of Contents
Advertisement
I
C
NTERFACE
OMMANDS
SHOW INTERFACE STATUS
show interface status
Overview
Use this command to display the status of the specified interface or interfaces.
Note that when no interface or interfaces are specified then the status of all
interfaces on the device are shown.
show interface [<port-list>] status
Syntax
Examples
To display the status of ports 1.0.1 to 1.0.4, use the commands:
awplus#
Table 2: Example output from the show interface <port-list> status command
awplus#show interface port1.0.1-1.0.4 status
Port
Name
port1.0.1
port1.0.2
port1.0.3
port1.0.4
To display the status of all ports, use the commands:
awplus#
Table 3: Example output from the show interface status command
awplus#show interface status
Port
Name
port1.0.1
port1.0.2
port1.0.3
port1.0.4
port1.0.5
port1.0.6
...
613-50157-01 Rev C
Parameter
Description
<port-list> The ports to display information about. The port list can be:
• a switch port (e.g. port1.0.6), a static channel group (e.g. sa2) or a
dynamic (LACP) channel group (e.g. po2)
• a continuous range of ports separated by a hyphen, e.g.
port1.0.1-1.0.6, or sa1-2, or po1-2
• a comma-separated list of ports and port ranges, e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix switch ports, static channel
groups, and dynamic (LACP) channel groups in the same list
show interface port1.0.1-1.0.4 status
Status
notconnect
notconnect
notconnect
notconnect
show interface status
Status
notconnect
notconnect
notconnect
notconnect
notconnect
notconnect
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
Vlan Duplex
Speed Type
1 auto
auto 10GBASE-T
1 auto
auto 10GBASE-T
1 auto
auto 10GBASE-T
1 auto
auto 10GBASE-T
Vlan Duplex
Speed Type
1 auto
auto 10GBASE-T
1 auto
auto 10GBASE-T
1 auto
auto 10GBASE-T
1 auto
auto 10GBASE-T
1 auto
auto 10GBASE-SR
1 auto
auto not present
331
Hide quick links:
Advertisement
Table of Contents
