Powering On; Switching On And Off The Main Line Switch On The Power Distribution Unit; Figure 5.3 Pc Terminal Connection For Initial Setup; Figure 5.4 On Position (Marked "|") Of The Main Line Switches On A 1U Power Distribution Unit - Fujitsu ETERNUS DX200 S3 Configuration Manual

Chapter 5 General Settings
5.2

Powering On

The ETERNUS DX Disk storage system and the PC terminal must be connected directly since the network
environment of the ETERNUS DX Disk storage system is set using the PC terminal for the initial setup of
the ETERNUS DX Disk storage system.

Figure 5.3 PC Terminal Connection for Initial Setup

PC terminal
Controller
enclosure
5.2 Powering On
This section explains how to turn on the ETERNUS DX Disk storage system.
5.2.1

Switching On and Off the Main Line Switch on the Power Distribution Unit

Turn the main line switch of the power distribution unit to the ON position (marked "|").
Make sure all of the main line switches are in the ON position.
●
For 1U

Figure 5.4 ON Position (Marked "|") of the Main Line Switches on a 1U Power Distribution Unit

Main line switch
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
LAN port
LAN cable
RMT port of Controller 0 (CM#0)
Copyright 2014 FUJITSU LIMITED
73
P3AM-7652-02ENZ0