Serverview (Snmp Trap Notification) Setup; Figure 7.35 [Setup E-Mail Notification] Screen (Mail Server Settings); Figure 7.36 Send Test E-Mail - Fujitsu Eternus DX60 User Manual

Chapter 7 Setup
> 7.4 Monitoring Setup
5
6
7
8
7.4.3

ServerView (SNMP Trap Notification) Setup

This section explains how to perform settings to monitor event notification (Trap) by SNMP using
"ServerView", when the ETERNUS DX60/DX80/DX90 is connected to the Industry standard
server PRIMERGY.
IMPORTANT
Refer
P3AM-3042-06ENZ0 ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Set the necessary items in the [Mail Server Settings] area.

Figure 7.35 [Setup E-Mail Notification] screen (Mail Server Settings)

After finishing the necessary settings, click the [Set] button.
A confirmation screen appears.
Click the [OK] button.
The specified send E-mail setting is registered.
Click the [Send Test E-mail] button to check that an E-mail can be sent to the
specified E-mail destination address.

Figure 7.36 Send Test E-mail

• Use ServerView whose version is V3.60L20 or later.
• For the details on the Industry standard server side settings, refer to
"ServerView User's Guide" that is provided with the PC server.
"ServerView User's Guide"
173
End of procedure
Copyright 2010 FUJITSU LIMITED