Lldp (802.1Ab) Commands; Lldp Transmit; Lldp Receive; Lldp Timers - NETGEAR ProSafe GSM7224P User Manual

LLDP (802.1AB) Commands

This section describes the command you use to configure Link Layer Discovery Protocol
(LLDP), which is defined in the IEEE 802.1AB specification. LLDP allows stations on an 802
LAN to advertise major capabilities and physical descriptions. The advertisements allow a
network management system (NMS) to access and display this information.

lldp transmit

Use this command to enable the LLDP advertise capability.
Default
enabled
Format
lldp transmit
Mode
Interface Config
no lldp transmit
Use this command to return the local data transmission capability to the default.
Format
no lldp transmit
Mode
Interface Config

lldp receive

Use this command to enable the LLDP receive capability.
Default
enabled
Format
lldp receive
Mode
Interface Config
no lldp receive
Use this command to return the reception of LLDPDUs to the default value.
Format
no lldp receive
Mode
Interface Config

lldp timers

Use this command to set the timing parameters for local data transmission on ports enabled
for LLDP. The <interval-seconds> determines the number of seconds to wait between
transmitting local data LLDPDUs. The range is 1-32768 seconds. The <hold-value> is the
multiplier on the transmit interval that sets the TTL in local data LLDPDUs. The multiplier
ProSafe Managed Switch
Switching Commands
186