D-Link DXS-3600 Series Reference Manual page 1290
Dxs-3600 series layer 2/3 managed 10gigabit ethernet switch
Hide thumbs
Also See for DXS-3600 Series:
- Cli reference manual (1456 pages) ,
- Reference manual (680 pages) ,
- Hardware installation manual (55 pages)
Table of Contents
Advertisement
DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Log Message: BGP-6-TOTALPFXMAX: The total number of prefix received
reaches max prefix limit.
Event description: BGP received unnecessary AS4-PATH attribute from new (4-
bytes AS) BGP peer
Log Message: BGP-4-RCVUNNECEAS4PATH: Received AS4-PATH attribute
from new (4-bytes AS) peer. (Peer <ipaddr>).
Parameters description:
ipaddr: IP address of BGP peer.
Event description: BGP received unnecessary AS4-AGGREGATOR attribute from
new (4-bytes AS) BGP peer
Log Message: BGP-4-RCVUNNECEAS4AGGRE: Received AS4-AGGREGATOR
attribute from new (4-bytes AS) peer. (Peer <ipaddr>).
Parameters description:
ipaddr: IP address of BGP peer.
Event description: BGP received AS_CONFED_SEQUENCE or
AS_CONFED_SET path segment type in AS4-PATH attribute.
Log Message: BGP-4-RCVASCONFEDINAS4PATH: Received
AS_CONFED_SEQUENCE or AS_CONFED_SET path segment type in AS4-
PATH attribute. (Peer <ipaddr>).
Parameters description:
ipaddr: IP address of BGP peer.
Event description: BGP received invalid AS4-PATH attribute.
Log Message: BGP-4-RCVBADAS4PATH: Received invalid AS4-PATH attribute.
Value : <STRING> (Peer <ipaddr>).
Parameters description:
STRING: Detailed description about the invalid attribute.
ipaddr: IP address of BGP peer.
Event description: BGP received invalid AS4- AGGREGATOR attribute.
Log Message: BGP-4-RCVBADAS4AGGRE: Received invalid AS4-
AGGREGATOR attribute. Value : <STRING> (Peer <ipaddr>).
Parameters description:
STRING: Detailed description about the invalid attribute.
ipaddr: IP address of BGP peer.
BPDU Protection
Log Description
Event description: Record the event when the BPDU attack happened.
Log Message: <interface-id> enter STP BPDU under protection state (mode:
<mode>)
Parameters description:
interface-id: Interface on which detected STP BPDU attack.
mode: BPDU Protection mode of the interface.
Mode can be drop, block, or shutdown
Event description: Record the event when the STP BPDU attack recovered.
Log Message: <interface-id> recover from BPDU under protection state.
Parameters description:
interface-id: Interface on which detected STP BPDU attack.
1290
Warning
Warning
Warning
Warning
Warning
Severity
Informational
Informational
Advertisement
Table of Contents
