Radius-Server Timeout - Cisco MDS 9124 - Fabric Switch Reference

Chapter 20 R Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

radius-server timeout

To specify the time between retransmissions to the RADIUS servers, use the radius-server timeout
command. You can revert the retransmission time to its default by issuing the no form of the command.
Syntax Description
seconds
Defaults 1 second
Command Modes
Configuration mode.
Command History Release
1.0(2)
Usage Guidelines None.
Examples
The following example configures the timeout value to 30 seconds.
switch# config terminal
switch(config)# radius-server timeout 30
Related Commands Command
show radius-server
OL-16217-01, Cisco MDS SAN-OS Release 3.x
radius-server timeout seconds
no radius-server timeout seconds
Specifies the time (in seconds) between retransmissions to the RADIUS
server. The range is 1 to 60 seconds.
Modification
This command was introduced.
Description
Displays RADIUS server information.
Cisco MDS 9000 Family Command Reference
radius-server timeout
20-11