Radius-Server Source-Ipv6; Radius-Server Timeout - Cisco 300 Series Cli Manual

RADIUS Commands
78-21075-01 Command Line Interface Reference Guide
18.5

radius-server source-ipv6

Use the radius-server source-ipv6 Global Configuration mode command to
specify the source IPv6 address used for communication with RADIUS servers.
Use the no form of this command to restore the default configuration.
Syntax
radius-server source-ipv6 {
no radius-server source-ipv6 {
Parameters
source—Specifies the source IPv6 address.
Default Configuration
The source IP address is the IP address of the outgoing IP interface.
Command Mode
Global Configuration mode
User Guidelines
If there is no available IP interface of the configured IP source address, an error
message is issued when attempting to communicate with the IP address.
Example
The following example configures the source IP address used for communication
with all RADIUS servers to 3ffe:1900:4545:3:200:f8ff:fe21:67cf.
switchxxxxxx(config)#
3ffe:1900:4545:3:200:f8ff:fe21:67cf
18.6

radius-server timeout

Use the radius-server timeout Global Configuration mode command to set how
long the device waits for a server host to reply. Use the no form of this command to
restore the default configuration.
source
}
source
}
radius-server source-ipv6
18
277