Show Module - Cisco MDS 9124 - Fabric Switch Reference

Chapter 22 Show Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

show module

To verify the status of a module, use the show module command.
Syntax Description
slot
recovery-steps
diag
uptime
xbar number
Defaults None.
Command Modes
EXEC mode.
Command History Release
1.3(4)
3.0(1)
Usage Guidelines If your chassis has more than one switching module, you will see the progress check if you issue the
show module command several times and view the status column each time.
The switching module goes through a testing and an initializing stage before displaying an
Use the uptime option to display the time that a specified supervisor module, switching module, or
services module is functional in the switch. This time is computed from the time a module goes online
after a disruptive upgrade or reset.
You can use the recovery-steps option only for modules that are powered down because of problems
with index allocation.
Before using the recovery-steps option, make sure that debug module no-power-down is not on.
You cannot use the recovery-steps option to recover a Supervisor module. Also, the Cisco MDS 9124
Note
switch does not support the recovery-steps option.
For additional information about port indices, refer to the Cisco MDS 9000 Family CLI Configuration
Guide and to the Cisco MDS 9000 Family Troubleshooting Guide.
Examples The following example displays information about the modules on the switch.
switch# show module
OL-16217-01, Cisco MDS SAN-OS Release 3.x
show module [slot [recovery-steps] | diag | uptime | xbar number]
Specifies the slot number for the module.
Displays information about modules and the steps to recover a module.
Displays module-related information.
Displays the length of time that the modules have been functional in the
switch.
Displays information about the specified crossbar, either 1 or 2.
Modification
This command was introduced.
Added the recovery-steps and xbar options.
Cisco MDS 9000 Family Command Reference
show module
status.
ok
22-255