Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1033

Configuration
Step-by-Step
Procedure
Copyright © 2010, Juniper Networks, Inc.
Figure 18: Default Configuration of Multimember Virtual Chassis in a Single
Wiring Closet
To configure a multimember Virtual Chassis access switch in a single wiring closet using
the factory defaults, perform this task:
To configure a multimember Virtual Chassis with default role assignments:
Make sure the dedicated VCPs on the rear panel are properly cabled. See Virtual
1.
Chassis Cabling Configuration Examples for EX4200 Switches for additional
information.
Power on the switch that you want to function as the master (SWA-0). This
2.
examples uses one of the larger switches (EX4200-48P) as the master.
Check the front panel LCD to confirm that the switch has powered on correctly and
3.
that a member ID has been assigned.
Run the EZSetup program on SWA-0, the master, specifying the identification
4.
parameters. See "Connecting and Configuring an EX Series Switch (CLI Procedure)"
on page 199 or "Connecting and Configuring an EX Series Switch (J-Web Procedure)"
on page 201 for details.
Configure SWA-0 with the virtual management Ethernet (VME) interface for
5.
out-of-band management of the Virtual Chassis configuration, if desired.
[edit]
user@SWA-0# set interfaces vme unit 0 family inet address /ip-address/mask/
After a lapse of at least one minute, power on SWA-1. This example uses the second
6.
EX4200-48P switch as the backup.
Check the front panel LCD to confirm that the switch has powered on correctly and
7.
that a member ID has been assigned.
Chapter 38: EX4200 Virtual Chassis—Configuration Examples
929